BL 6 inch 80 pounder gun

• Name — Ordnance BL 6-inch 80-pounder Mk I • Origin — United Kingdom • Type — Naval gun Coast defence gun • Is Ranged — YES • Is Artillery — YES • Is Uk — YES • Service — 1880–1943 • Used By — Royal Navy Australian Colonies • Designer — Elswick Ordnance Company • Manufacturer — Elswick Ordnance Company • Variants — Mk I • Weight — 80 or 81 cwt (4 tons) • Part Length — 153 – 156 inches • Cartridge — 80 lb Palliser, Shrapnel, common • Caliber — 6 in • Velocity — 1880 ft/s • Max Range — 8000 yd • Breech — 3 motion interrupted screw. Elswick cup obturation

• Illustration — 6-inch 80-pounder 80 cwt gun Mk I of 80 cwt (4 tons) as originally built was an Elswick Ordnance design which was weakly made and fired only an 80 lb projectile. It consisted of a steel barrel with wrought-iron coils shrunk over it. A few guns were issued to the Royal Navy but most were replaced by the later versions. Mk I guns remaining in British service were rebuilt with "chase hoops" added around the barrel for strengthening, and the barrel was shortened by 3 inches to keep its centre of gravity at the trunnions. This resulted in the 81 cwt Mk I gun. The breech was rotated to the left to lock it, unlike standard British service BL guns made by the Royal Gun Factory which all rotated to the right to lock. These guns are commonly referred to as "6-in. 81-cwt B.L.R." in contemporaneous publications such as Brassey's Naval Annual. The official designation in British ordnance manuals was "80-pounder BL" to differentiate it and its ammunition from the later marks of 6-inch BL guns which fired 100-pound projectiles.

• Illustration — Quarterdeck of Protector with aft 6-inch gun trained to port, circa. 1903 Australian colonies and New Zealand purchased various 6-inch guns direct from the manufacturers, usually Elswick Ordnance Company, and these versions do not correspond directly with the official "Marks" as adopted by the British government. Specifications of guns purchased by Australian colonies are similar to those of the original British Mk I 80 cwt gun, firing an 80-pound projectile. The gun equipped some gunboats of the Australian colonial navies: • HMQS Paluma • HMQS Gayundah • HMCS Protector • HMVS Victoria of 1884 • HMVS Albert of 1884 Also on armed harbour vessels in Victoria: • Gannet: tug • Batman: hopper barge / dredge • Fawkner: hopper barge / dredge

• Illustration — Common shell diagram • Illustration — Full charge (top) and reduced charge (bottom) powder cartridges

• A 4-ton 80-pounder gun at Fort Glanville, Adelaide, South Australia • A 4-ton 80-pounder gun in Bundaberg Botanic Gardens, Bundaberg, Queensland Australia • A restored gun from HMAS Protector is outside the Naval Reserve Cadets building in Jenkins Street, Birkenhead, Adelaide • The aft gun from HMQS Paluma is in the Treloar Centre at the Australian War Memorial, in Canberra

The following is established of the heading itself. Classified as a naval artillery or rifled breech loader. Associated with United Kingdom of Great Britain and Ireland.