Besa Machine Gun

It was used extensively by the armed forces of United Kingdom during the Second World War as a mounted machine gun for tanks and other armoured vehicles as a replacement for the heavier, water-cooled Vickers machine gun. Although it required a rather large opening in the tank's armour, it was reliable.

Although British forces used the.303 in rimmed round for rifles and machine guns, the ZB-53 had been designed for the German 7.92×57mm Mauser round; referred to by the British as the 7.92 mm. The British had intended to move from rimmed to rimless ammunition but with war imminent, wholesale change was not possible. It was falsely believed by BSA and the Ministry of Supply that the industrial, technical and supply difficulty of converting the design to the.303 round would be more onerous than retaining the original calibre, especially given that the chain of supply for the Royal Armoured Corps was already separate from the other fighting arms of the British Army and the round was not changed for British production. Since the Besa used the same ammunition as Germany used in its rifles and machine guns, the British could use stocks of captured enemy ammunition, albeit without the ability to use their ammunition belts as packaged. The.303 version of the ZB-53 was presented to the British officials in early 1937 and passed field trials in November 1937 with flying colours (0.5% of stoppages), however in September 1937 the Small Arms Committee had already decided it wanted the 7.92 mm version for which BSA was already tooling up because of the urgency. The Mark II version, license-produced by BSA in Birmingham as opposed to ZB's Mk I, entered service in June 1940. The design was modified to be more rapidly and economically produced and three simplified models, the Mark II*, Mark III and Mark III*, entered service in August 1943. The Mark II* was a transitional model designed to use the new simplified parts but was compatible with the Mark II. All those versions had a selector to give a high rate of fire (750–850 rounds per minute) for close combat or focused targets or a low rate of fire (450–550 rounds per minute) for long-range combat or area targets. The Mark III and Mark III* versions did away with this selector and had simplified parts like the Mark II* but were incompatible with the Mark II. The Mark III had a fixed high rate of fire (750–850 rpm) and the Mark III* had a fixed low rate of fire (450–550 rpm) Damaged or malfunctioning Mark IIIs were converted to Mk III* at factories during repair. The earlier wartime Mark I, Mark II and Mark II* versions of the Besa 7.92 mm were declared obsolete in 1951 and all Mark III versions were converted to Mark III*. The Mark III/2 introduced in 1952 was a conversion of the Mark III* with a new bracket and body cover. The later Mark III/3 introduced in 1954 was a conversion of the Mark III/2 that replaced the barrel and sleeve and made the gas vents larger on the gas cylinder to make it easier to use belts of mixed ammunition. The post-war Mark III/2 and Mark III/3 remained in service until the late 1960s.

A larger, heavier 15 mm version (also belt-fed) was developed by BSA from the Czechoslovak ZB-60 heavy machine gun as vehicle armament. It could be fired in semi-automatic mode as well as fully automatic. It was introduced in British service in June 1940 and was used on the Light Tank Mk VIC and on armoured cars such as the Humber Armoured Car Marks I–III. Over 3,200 15 mm Besa were manufactured until it was declared obsolete in 1949. It fired a 75 grams (1,160 gr) bullet from a 15×104 mm cartridge with a muzzle velocity of 818.3 m/s (2,685 ft/s) at a rate of 450 rounds per minute. The 15 mm Besa was fed from 25-round metal belts, which limited its practical rate of fire, although the weapon was usually used for single shots as it was difficult to fire accurately in automatic.