Smith & Wesson Model 13

• Name — Smith & Wesson Model 13 • Origin — United States • Type — Revolver • Is Ranged — yes • Used By — United States, Hong Kong • Manufacturer — Smith & Wesson • Unit Cost — $242 (1983) $547 (2004) • Production Date — 1972–2004 • Variants — Model 65 (stainless steel) Model 65LS (LadySmith) • Weight — 31 oz. (3" bbl) • Length — 8" (with 3" barrel) 9" (with 4" barrel) • Part Length — 3" or 4" • Cartridge —.357 Magnum,.38 Special • Action — Double action • Feed — Six-round Revolving cylinder • Sights — Fixed (rear notch; front ramp)

The Model 13 is a double-action revolver with a capacity of six rounds. Barrel lengths are 3-inch and 4-inch with fixed sights. Both round-butt and square-butt versions were produced. The Model 19 is essentially the same gun with adjustable sights and a partial underlug. The Model 13 has a blued finish; the Model 65 is a variant in matte finish stainless steel. The Model 13 was manufactured from 1974 to 1999. The Model 65 was manufactured from 1972 to 2004. The Model 13 should not be confused with the M13, which was a lightweight alloy revolver produced from 1954 to 1956 for the U.S. Air Force, known as the Colt Aircrewman.

Engineering and production changes of the Model 13, indicated as a dash after the model number stamped on the frame: • Model — Year — Modifications • 13-1 — 1974 — Introduced for the NYSP with model # stamping • 13-2 — 1977 — Changed from gas ring on yoke to cylinder • 13-3 — 1982 — Eliminated cylinder counterbore and pinned barrel/small change in cylinder length to 1.62" • 13-4 — 1988 — New yoke retention system/radius stud package/floating hand/hammer nose busing • 13-4 — 1994 — Synthetic grips, change extractor • 13-4 — 1995–1996 — Delete square butt features • 13-4 — 1996 — Begin shipment in foam lined blue plastic case, Begin serrated backstrap and fore strap on a round butt frame for 18 months, then discontinued • 13-4 — 1997 — Discontinued 3" barrel / change to MIM thumb piece and trigger, ship with Master trigger lock • 13-5 — Changes to frame design, cylinder stop stud eliminated, changed to MIM hammer with floating firing pin, changes to internal lock works • 13-5 — Discontinued Model 13 with few produced

Both models were issued by police agencies and federal law enforcement agencies in the United States. The Model 13 was requested by the New York State Police in order to have a.357 Magnum revolver to replace their Model 10.38 Special. The Model 65 in stainless steel came about at the request of the Oklahoma Highway Patrol. The FBI issued the Model 13 with round butt and 3" heavy barrel shortly before switching to semi-automatic pistols. The Model 13 was the last revolver issued by the FBI. It was an unqualified success with Special Agents. The round-butt K-frame with 3" barrel in.357 Magnum proved to be an ideal sidearm for an investigative agency. The Model 65 is used by the Texas Department of Criminal Justice.

* • Royal Canadian Mounted Police • Hong Kong • Independent Commission Against Corruption * • Anne Arundel County Police Department • DuPage County Sheriff's Department • Federal Bureau of Investigation • Fort Worth Police Department • Georgia Board of Pardons and Parole • Iowa State Police • Maine State Police • Maryland State Police • Massachusetts State Police • New York State Police • North Carolina Department of Corrections • Oklahoma Highway Patrol • Sacramento County Sheriff's Department • San Antonio Police Department • Shelby County Sheriff's Department (Tennessee) • Tampa Police Department • Texas Department of Criminal Justice • Wayne County Sheriff's Office (Michigan)

Smith & Wesson Model 13 is associated with United States. Classified as a revolver. Connected to 1 other published record in the VALÉORINE Encyclopedia.