.38 Long Colt

It is slightly more powerful than the.38 Short Colt, also known as.38 SC. The original.38 SC and.38 LC differ in case length, bullet diameter, weight, and design and are not interchangeable; however, modern production.38 SC ammunition is now loaded with a smaller, internally-lubricated bullet which can be fired from firearms chambered in.38 LC or.38 Special. The modern.38 LC can be fired from a.38 Special firearm, but not from a firearm designed for the.38 SC, since the case length is too long.

• Name —.38 Long Colt • Origin — United States • Type — Revolver • Service — 1892–1909 • Used By — United States Army • Designer — Colt • Manufacturer — Colt • Production Date — 1875 • Parent —.38 Short Colt • Case Type — Rimmed, straight • Bullet —.357 • Neck —.381 • Base —.381 • Rim Dia —.445 • Rim Thick —.060 • Case Length — 1.031 • Length — 1.360 in (34.54 mm) • Max Pressure — 13000 • Pressure Method — CIP • Bw1 — 125 • Btype1 — LRN • Vel1 — 772 • En1 — 165 • Bw2 — 150 • Btype2 — LRN • Vel2 — 777 • En2 — 201 • Balsrc — Hodgdon Reloading Data Center

• Illustration — Diagram of.38 Long Colt U.S. Army "ball cartridge", with dimensions in inches. The.38 Long Colt's predecessor, the.38 Short Colt, used a heeled bullet of 130 gr at a nominal 770 ft/s, producing 165 ft·lbf muzzle energy. The cylindrical "shank" or "bearing surface" of the bullet, just in front of the cartridge case mouth, was.374 or in diameter, the same as the outside diameter of the cartridge case (as in.22 rimfire cartridges). A smaller-diameter portion of the bullet, the "heel", was crimped inside the case mouth, and the lubricant was outside the case, and exposed. In contrast, the.38 Long Colt uses a bullet which on the outside of the cartridge case is only.357 –, the bearing surface and lubricant being entirely contained within the case. This kept the waxy lubricant from collecting grit which can damage the revolver's barrel. Colt, however, retained the single-diameter charge hole, resulting in the bullet failing to form a seal as it traveled through the chamber throat. This seal was expected to cause the bullet to expand in the throat and be "swaged down", or reduced again in diameter, as it entered the barrel, but uneven expansion produced poor accuracy. In the United States Army's original black-powder cartridge used by the Colt M1892 revolver, muzzle velocity from the revolver's 6 in barrel with bore diameter.363 in (.369 in groove diameter) was 708 ft/s with a bullet weighing 150 gr, resulting in a muzzle energy of 167 ft.lbf. In 1903, the Army changed its cartridge to smokeless powder and slightly tightened the revolver's bore to.357 in (.363 in groove diameter); the new muzzle velocity was 750 ft/s with a bullet of 148 gr, giving a muzzle energy of 185 ft.lbf.

The cartridge's relatively poor ballistics were highlighted during the Philippine–American War of 1899–1902, when reports from U.S. Army officers were received regarding the.38 bullet's inability to stop charges of frenzied Moro juramentados during the Moro Rebellion, even at extremely close ranges. A typical instance occurred in 1905 and was later recounted by Colonel Louis A. LaGarde: Antonio Caspi, a prisoner on the island of Samar, P.I. attempted escape on Oct. 26, 1905. He was shot four times at close range in a hand-to-hand encounter by a.38 Colt's revolver loaded with U.S. Army regulation ammunition. He was finally stunned by a blow on the forehead from the butt end of a Springfield carbine. Col. LaGarde noted Caspi's wounds were fairly well-placed: three bullets entered the chest, perforating the lungs. One passed through the body, one lodged near the back and the other lodged in subcutaneous tissue. The fourth round went through the right hand and exited through the forearm. As an emergency response to the round's unexpectedly dismal performance, the U.S. Army authorized officers to carry M1873 Colt Single Action Army revolvers, chambered in.45 Colt, and issued from reserve stocks. Army Ordnance also purchased a number of M1902 revolvers (the M1902 was an improved version of Colt's Double Action Army Model 1878, a.45-caliber rod-ejector double-action revolver) for issue to officers deploying overseas. The.38 Long Colt remained the Army's primary revolver cartridge until 1909, when the.45 M1909 cartridge was issued along with the.45 Colt New Service revolver as the new standard military sidearm for the U.S. Army. However, some of the old.38 Long Colt revolvers and ammunition remained in reserve stocks, and when the U.S. entered World War I in 1917, the need for sidearms was such that even these low-performing weapons were brought out of storage for usage away from the front lines. In civilian use, the.38 LC was chambered in a number of Colt revolvers and saw some use among target shooters. Various U.S. police forces also adopted the cartridge. However, the cartridge became nearly extinct after Smith & Wesson's more powerful.38 Special cartridge became widely popular as a civilian and police service cartridge. By 1908, even Colt was chambering their new Police Positive and Army Special revolvers in ".38 Colt Special", which was just a standard.38 Smith & Wesson Special with a different headstamp.